elevator car

英 [ˈelɪveɪtə(r) kɑː(r)]

美 [ˈelɪveɪtər kɑːr]

网络  电梯轿厢; 轿厢; 电梯车厢

英英释义

noun

• where passengers ride up and down
  1. the car was on the top floor
  Synonym:car

双语例句

• Horizontal vibration model of elevator car
  电梯轿厢水平振动模型
• A diagram showing the location of your elevators, car numbers and the elevator car phone number should be in your designated security area.
  在指定的安全区域，应有一张体现电梯位置，电梯厢号以及电梯里电话号码的图表。
• Finite Element Analysis on A Hydraulic Elevator Car Frame
  液压电梯轿厢架的有限元计算
• ⑵ Through MATLAB software on traction elevators were 12 degrees of freedom vibration model and the horizontal direction perpendicular to 8 degrees of freedom vibration model simulation, respectively, high-speed elevator car by the maximum peak to peak vertical vibration and horizontal vibration of the dynamic model curve.
  ⑵利用MATLAB软件分别对曳引电梯的12自由度垂直振动模型和水平方向8自由度振动模型进行仿真，分别得到高速电梯轿厢垂直振动的最大峰峰值与水平振动的动力学模型曲线。
• An elevator car controller based on CAN bus is described. The functions, architecture, hardware and software and the communication protocol designing methods of this controller are introduced.
  简述了一种基于CAN总线的电梯轿厢控制器，介绍了该控制器的功能、结构及其软硬件和通信协议的设计方法。
• As a part of stereo-garage, the elevator for car is playing an important role in parking industry.
  汽车专用升降机作为立体车库的一部分，在停车行业中起着越来越重要的作用。
• For optimization efficiency of the elevator, the elevator car occupancy percentage is an important data. Existing weight measure system can only measure the weight in the elevator car and can not identify the occupancy percentage.
  对于电梯效率最优化而言，轿厢空间被占用面积是一个关键数据，但现有的电梯称重装置只能检测出轿厢中的重量，无法识别轿厢空间占用率。
• It analyzes a hydraulic elevator car frame used in the museum, sets up its multi-loops structure and variable working conditions load.
  某博物馆液压电梯轿厢架具有多重框架的结构特点和变工况的载荷特征，传统公式计算法难于进行应力和变形分析。
• Vibration acceleration response of the elevator car is used as feedback signal and thus the engineering implementation of the active control will be simplified.
  采用电梯矫厢的振动加速度作为反馈信号，将使主动控制在工程上易于实现。
• This paper establishes the model of the transmission system of the PQS-3-D Elevator for Car with the traditional approach of modeling and analyzes the model in vertical direction to meet the needs of market and design.
  本论文就是在这种形势下，响应市场的需求和设计的需要，对PQS-3-D型汽车专用升降机的机械传动系统，采用动力学理论建模方法，进行垂直方向上的建模及分析。